Commercial insulation in Auburn, AL - a cooler building, done around your hours
Hot offices under a metal roof or an AC that never catches up? We insulate around your hours and match your approved plans.
How do you insulate a business in Auburn without disrupting it?
Commercial insulation in Auburn, AL means sealing and insulating the roof, walls and frame of a shop, office or metal building so the cooled rooms stay cool, and at Quality Auburn Spray Foam Insulation we plan that work around the hours your building can sit empty.
Most calls come from owners and managers with a back office that's hot by noon, a power bill that keeps climbing, or two quotes that don't seem to describe the same job. The price mostly comes down to the size of the building, the roof and wall type, the method that fits and whether old insulation has to come out first. The schedule turns on when the building can sit empty and, on a remodel, on the city's plan review. The estimate I write lists every step in the order we'd do it, so you can lay it beside another quote and see where they differ.
What our commercial insulation work covers
I start by walking the building and reading the plans your project sends to the city, because the insulation we put in should match what was approved. Then we set the schedule around the hours your building can sit empty, with the spray foam days on days you're closed. Once we're in, our crew seals the gaps around pipes, conduit and the seams where the walls meet the roof before anything gets covered, since insulation over an open gap just fights a draft. If we find a roof leak, I'll tell you and we'll hold off on that area until it's fixed, because roofing isn't our work and insulation over a leak holds the water against the frame. We keep the vents open, carry the depth all the way to the edges where it usually runs thin, and clean up before you reopen.
Some buildings need moisture work alongside the insulation. If yours sits over a crawl space, we can put in a crawl space vapor barrier so ground moisture stays out of the floor. Where the plans call for a moisture layer in the walls or roof, our vapor barrier installation puts it where the plans show it.
What Auburn's plan review means for commercial insulation
In Auburn, the city's Inspection Services Department reviews submitted plans and inspects all new and remodeled buildings inside city limits, and its commercial policies ask for the drawings to show energy code compliance and the insulation values. So the insulation in your building is part of what the city approves, which is why we work from those plans and check with the office before we start, pulling any permit the work calls for. Alabama also requires an energy code to be enforced for commercial buildings. If your building is a hotel, motel or movie theater, the state's Division of Construction Management has authority over it too, since those are the only commercial buildings it covers, and we'll check with them when a question comes up that only they can answer.
We're based in Auburn and work in the cities around it. Most commercial calls we get are metal shops, warehouses and small offices where the rooms under the roof heat up by afternoon, and the air usually escapes where the walls meet the roof and around big doors. We see the same buildings on jobs in Opelika and Tuskegee, and we seal those seams first there too.
How commercial insulation works
Call us or send the form
Tell us what kind of building it is and what's bothering you about it. We'll set a time for me to come look.
I walk it and write it up
I look at the roof, walls and any crawl space, ask what's going on and write an estimate with the steps listed in the order we'd do them. You'll see what's included and what drives the price before you decide anything.
We check permits and set dates
Before work starts we check the permit question with the city or county office for your address. Then we put the spray foam days on the calendar for when your building is closed.
Our crew installs, we walk it
A crew lead runs the install from start to finish. At the end I walk the building with you so you see what's sealed and covered before it's out of sight.
Get a written plan and price for your building
We reply to every call or form within one business day. I'll set a time to come out, look at the building and write a free estimate with the work listed in order. There's no pressure and no obligation to book.
What owners ask about commercial insulation
How much does commercial insulation cost in Auburn, AL?
Your price comes from the building's size, the roof and wall type, the method and whether old insulation has to come out first, and I put it in writing after I've seen the building. Spray foam costs more than fiberglass or board, but it seals air as it goes on, which usually pays off where ductwork runs through the roof space. Otherwise sealing the gaps and adding fiberglass or board often does the job for less, so call (334) 780-0054 to set up the visit.
Is rigid board above the roof deck better than attic insulation?
For a commercial roof, usually yes. An Alabama commercial field guide calls an unbroken layer of rigid board above the deck a more effective use of roof insulation than attic insulation, because it resists the sun's heat steadily and cuts the heat moving down into the cooled rooms. It goes on top of the deck, so it fits best when the roof is open anyway for a replacement or a new build.
How is a metal building insulated?
Traditionally the erector drapes rolls of fiberglass with a vapor retarder facing, a layer that slows moisture, over the frame with the facing toward the inside, and the outer metal skin closes over it. In an older building I look for torn facing and sagging rolls, since a gap there lets damp air reach the metal.
How long does a building have to stay empty for spray foam insulation?
Plan on the building being empty while the foam goes on and for a while after. EPA guidance says to schedule spray foam so no other trades or occupants are inside during the install, and some manufacturers recommend 24 hours before people come back, though the re-entry time, the wait before anyone returns, can vary by product. We set the foam days for when you're closed and go by the wait the product we use calls for.
How do I apply for a commercial building permit in Auburn?
Permit forms go to the city's Inspection Services Department, and you can also complete them through the Auburn Permit Portal from the city's permit applications page. If you're not sure whether your insulation job needs one, ask me when I come out and I'll tell you what we'll check with the office.
What licenses does a commercial insulation contractor need in Auburn, AL?
Auburn's commercial plan checklist asks for a current State Commercial Contractor license and a current City of Auburn Contractor license. You can look up any contractor on the state licensing board search before you hire, us included.
Why Auburn businesses call Quality Auburn Spray Foam Insulation for commercial insulation
In business since 2013
I learned this trade under an old school contractor who climbed in behind me and made me redo anything that wasn't right. I still work that way, because a covered mistake is still a mistake.
The owner sees every job
I come out to look at your building and write the estimate myself, and I look over the crew's work before we leave. The person who priced the job is the one who checks it.
Licensed and insured
We're licensed and insured. That protects your building and your people while our crew is working in the roof and walls.
Installed to your approved plans
Since Auburn's review looks at the insulation values on your drawings, we install to those plans instead of our own idea of the job. If something on site doesn't match the plans, I'll show you before we go further.
I'd rather answer your tenth question than have you sign something you don't understand. Send us your building details or call (334) 780-0054, and I'll come take a look.
Other work that often goes with it
Crawl space vapor barrier
If your building sits over a crawl space, a ground cover keeps damp soil from soaking the floor framing and the insulation above it.
Vapor barrier installation
When your plans call for a moisture layer, this puts it on the side they show so condensation has nowhere to collect.
Tell us when your building can sit empty
Call (334) 780-0054 or send the form with your building type, roof type and the hours it can sit empty, so I can plan the visit and the foam days around them before I arrive.
